ToEnsureSafety
ELECTRICAL SAFETY
The printer should be in a ventilated environment to prevent from humidity and heating.
Operate the machine with dry hands.
Check power supply voltage and grounding by an authorized electrician.
Power supply input requirement is 115VAC/60Hz. Check the input voltage switches of the four power supplies in the
front electrical cabinet.
MECHANICAL SAFETY
Move the machine with forklift.
Ground the printer on a flat place in a dry environment.
Make working place clean and in order.
Use emergency stop button to stop every moving part of the printer immediately and cut off all power supply.
GENERAL WARNING
Electrical Danger
- Use the power supply voltage specified on the nameplate. Avoid overloading the printer’s electrical outlet with multiple
devices.
- Be sure the printer is well-grounded. Failure to ground the printer may result in electrical shock, fire, and susceptibility
to electromagnetic interference.
- Use only the electrical cord supplied with the printer. Do not damage, cut, or repair the power cord. A damaged power
cord has risk of fire and electric shock. Replace a damaged power cord with an manufacturer approved one.
- Cut power off and unplug the power cable in any of the following cases:
1) When placing your hands inside the printer.
2) When there is smoke or an unusual smell coming from the printer.
3) When the printer is making an abnormal noise.
4) When a piece of metal or a liquid (no part of cleaning and maintenance routines) touches internal parts of the
printer.
5) During an electrical (thunder/lightning) storm.
6) During a power failure.
Danger of Fire
- Do not operate printer within 8 meters (25 feet) of open flames, sparks, or other sources of ignition. Do not SMOKE
within 8 meters (25 feet) of the printer.
To Next Page