Innova OBD2 - Viewing the Firmware Version

Additional Tests
VIEWING THE FIRMWARE VERSION
122 3140d
- Use the UP and DOWN buttons, as necessary, to
highlight the appropriate manufacturer, then press the
ENTER
button to display the correct DTC for your vehicle.
A confirmation message shows on the LCD display.
- If the correct manufacturer is
shown, use the UP
and
DOWN
buttons, as necessary,
to highlight YES then press the
ENTER
button to continue.
- If the correct manufacturer is not shown, use the UP
and
DOWN
buttons, as necessary, to highlight NO then press
the ENTER
button to return to the list of vehicle
manufacturers.
If a definition for the DTC you
entered is not available, an
advisory message shows on the
scan tool’s display.
6. If you wish to view definitions for
additional DTCs, press the ENTER
button to return to the Enter DTC screen,
and repeat steps 3 and 4.
7. When all desired DTCs have been viewed, press the DTC/FF button
to return to the Enter DTC screen (if necessary), then press the M
button to exit the DTC Library.
VIEWING THE FIRMWARE VERSION
You can view the current firmware version for the scan tool.
1. With the scan tool in OBD2 mode, press
and release the M button.
 The Main Menu displays.
2. Use the UP
and DOWN buttons,
as necessary, to highlight Firmware
Version in the Main Menu, then press
the ENTER
button.
 The Firmware Version screen displays.
 The screen shows the scan tool’s
current firmware version, bootloader
version and database version.
3. Press the M button to return to the Main
Menu.