Additional Tests
VIEWING VEHICLE INFORMATION
116 3140d
Status is calculated by the scan tool by comparing the Test
Value against the displayed test limit (either Min or Max).
Status is shown as either Low, High or OK.
5. Press the M button to return to the “Select Test” screen. When you
have finished viewing the retrieved test data, press the M button to
return to the “Special Test Menu” screen.
6. Repeat steps 3 through 5 to view test results for additional tests.
EVAP Leak Test
The EVAP Leak Test function lets you initiate a leak test for the
vehicle's EVAP system.
The scan tool does not perform the leak test, but signals to
vehicle's on-board computer to initiate the test. The vehicle
manufacturer determines the criteria and method for stopping
the test once it has been started. BEFORE using the EVAP
Leak Test function, refer to the vehicle's service repair manual
to determine the procedures necessary to stop the test.
1. From the "Special Test Menu", use the
UP
and DOWN buttons as
necessary, to highlight EVAP Leak Test,
then press the ENTER
button.
2. A "One moment please..." message
displays while the request is sent to the
vehicle's on-board computer.
Some vehicle manufacturers do not
allow scan tool’s or other external
devices to control vehicle systems. If
the EVAP Leak Test is not
supported by the vehicle under test,
an advisory message shows on the
scan tool's display. Press the M
button to return to the System Test
menu.
3. When the EVAP leak test has been
initiated by the vehicle's on-board
computer, a confirmation message
shows on the scan tool's display. Press
the M button to return to the “Special
Test Menu.”
VIEWING VEHICLE INFORMATION
The Vehicle Info function offers three options for retrieving reference
information for the vehicle under test; Vehicle ID, Available Modules
and IPT (In-Use Performance Tracking).
To Next Page
Loading...
