Inovance IS580 Series - Page 61

IS5800 User Manual Chapter 5 Maintenance and Troubleshooting
- 59 -
Figure 5-4 Err05 (Overvoltage during acceleration)
Err05
Check whether the input voltage of the
servo drive is too high
.
Check whether there is an external force to drive
the motor during acceleration.
Check whether the acceleration time is too short.
No
No
No
Contact the agent or Inovance.
Adjust the input voltage to the normal
range.
Remove the external force or install a
braking resistor.
Increase the acceleration time.
Yes
Yes
Yes
Check whether the braking unit and braking
resistor are installed.
Yes
No
Install the braking unit and braking
resistor.
Figure 5-5 Err06 (Overvoltage during deceleration)
Err06
Check whether the input voltage of the
servo drive is too high.
Check whether there is an external force to drive
the motor during acceleration.
Check whether the deceleration time is too short.
No
No
No
Contact the agent or Inovance.
Adjust the input voltage to the normal
range.
Remove the external force or install a
braking resistor.
Increase the deceleration time or
install a braking resistor.
Yes
Yes
Yes
Check whether the braking resistor is installed.
Yes
No
Install a braking resistor.