Inovance IS580 Series - Introduction to EMC Standard

IS580 User Manual Chapter 8 EMC
- 93 -
8.2 Introduction to EMC Standard
8.2.1 CE Mark
The CE mark on the IS580 declares that the AC drive complies with the European low voltage directive (LVD) and
EMC directive.
8.2.2 EMC Standard
The IS580 series AC drive complies with the international standards listed in the following table.
Directive Directive Code Standard
EMC directive 2004/108/EC EN 61800-3
EN 55011
EN 61000-6-2
LVD directive 2006/95/EC
93/68/EEC
EN 61800-5-1
The IS580 series servo drive satises the requirements of standard EN 61800-3. 2004 Category C2. The Servo
drives are applied to both the rst environment and the second environment.
8.2.3 Installation Environment
The system manufacturer using the servo drive is responsible for compliance of the system with the European
EMC directive. Based on the application of the system, the integrator must ensure that the system complies with
standard EN 61800-3. 2004 Category C2, C3 or C4.
The system (machinery or appliance) installed with the servo drive must also have the CE mark. The system
integrator is responsible for compliance of the system with the EMC directive and standard EN 61800-3. 2004
Category C2.
WARNING
If applied in the rst environment, the servo drive may generate radio interference. Besides the CE compliance described
in this chapter, users must take measures to avoid such interference, if necessary.