Inovance IS580 Series - Wiring of the ISMG Servo Motor

IS580 User Manual Chapter 6 ISMG Servo Motor (Voltage Class: 400 V)
- 77 -
6.5 Wiring of the ISMG Servo Motor
6.5.1 Terminals of PCB Board
The signal types of the terminals are dened on the PCB board. AC1 and AC2 are power supply (single-phase 220
V) to the cooling fan. AC1 and AC2 should be wired strictly according to the marks.
The matched signal lines of the IS580 servo drive are dened as below:
Signal Denition REF- REF+ COS+ COS- SIN+ SIN-
Adapted Encoder Cable Color Yellow-white Red-white Red Black Yellow Blue
Corresponding IS580 PG Card Pin 1 2 3 4 5 9
6.5.2 Precautions on Power Terminals Matched with PCB Board
When wiring the main circuit, ensure that the phase sequence conform to the marks. Connect PE terminal to the
xed screw with a special mark in the connection box.
Note
•
PTC, KTY, and resolver signal cable cannot connect to the 220 V power supply. Otherwise, the motor
will be damaged.
•
The motor has passed the IP54 experiment. At wiring, protection measures must still be taken at the
cabling holes to prevent foreign matters from falling into the motor.
•
Sticky dust in the working environment will weaken heat dissipation of the motor. Refer to section 6.6 to
clan the cooling fan.