Inovance IS580 Series - Use of the Operation Panel

Chapter 3 Mechanical and Electrical Installation IS580 User Manual
- 34 -
3.8 Use of the Operation Panel
The IS580 has a built-in LED operation panel. An external LED operation panel can also be connected to the RJ45
interface of the IS580 by an 8-core at cable.
You can modify the parameters, monitor the working status and start or stop the IS580 by operating the operation
panel, as shown in the following gure.
Figure 3-22 Diagram of the operation panel
MF.K
RUN
STOP
RES
QUICK
PRG ENTER
RUN
LOCAL/REMOT FED/REV TUNE/TC
RPM
%
A VHz
Command source
indicator
ON: terminal control
OFF: operation panel control
RUN indicator
Data display
Programming key
Menu key
RUN key
Forward/Reverse
rotation indicator
ON: reverse rotation
OFF: forward rotation
Tuning/Torque
control/Fault indicator
Unit indicator
Reserved
Stop/Reset key
Shift key
Increment key
Decrement key
Confirm key
3.8.1 Description of Indicators
•
RUN
ON indicates that the servo drive is in the running state, and OFF indicates that the servo drive is in the stop
state.
•
LOCAL/REMOT
It indicates whether the servo drive is operated by means of operation panel, terminal or communication
(remote).
LOCAL/REMOT: OFF Operation panel control
LOCAL/REMOT: ON Terminal control
LOCAL/REMOT: blinking Communication control