Inovance IS580 Series - Viewing and Modifying Function Codes

IS580 User Manual Chapter 3 Mechanical and Electrical Installation
- 35 -
•
FWD/REV
ON indicates reverse rotation, and OFF indicates forward rotation.
•
TUNE/TC
When the indicator is ON, it indicates torque control mode. When the indicator is blinking slowly, it indicates
the auto-tuning state. When the indicator is blinking quickly, it indicates the fault state.
•
Unit indicators
means that the indicator is ON, and means that the indicator is OFF.
Hz A V
RPM
%
Hz: unit of frequency
Hz A V
RPM
%
A: unit of current
Hz A V
RPM
%
V: unit of voltage
Hz A V
RPM
%
RPM: unit of rotational speed
Hz A V
RPM
%
%: percentage
3.8.2 Digital Display
The 5-digit LED display is able to display the set frequency, output frequency, monitoring data and fault codes.
The following table describes the keys on the operation panel.
Key Name Function
PRG
Programming Enter or exit Level I menu.
ENTER
Conrm Enter the menu interfaces level by level, and conrm the parameter setting.
Increment Increase data or function code.
Decrement
Decrease data or function code.
Shift
Select the displayed parameters in turn in the stop or running state, and select
the digit to be modied when modifying parameters.
RUN
Run Start the servo drive in the operation panel control mode.
STOP
RES
Stop/Reset
Stop the servo drive when it is in the running state and perform the reset
operation when it is in the fault state.
QUICK
Quick Enter or exit Level I quick menu.
MF.K
Reserved Reserved