Inovance IS580 Series - Page 37

Chapter 3 Mechanical and Electrical Installation IS580 User Manual
- 36 -
3.8.3 Viewing and Modifying Function Codes
The operation panel of the IS580 adopts three-level menu.
The three-level menu consists of function code group (Level I), function code (Level II), and function code setting
value (level III), as shown in the following gure.
Figure 3-23 Operation procedure on the operation panel
F0
F0-06
50.00
PRG
PRG
ENTER
ENTER
0.000
ENTER
PRG
F0-07
ENTER
PRG
Next function
code
/
Status parameter
(Default display)
(Select the function
code group)
Level-I menu
(Select the
function code)
Level-II menu
(Set the value of
the function code)
Level-III menu
Not to save
the setting
To save
the setting
You can return to Level II menu from Level III menu by pressing
PRG
or
ENTER
.
•
After you press
ENTER
, the system saves the parameter setting rst, and then goes back to Level II menu and
shifts to the next function code.
•
After you press
PRG
, the system does not save the parameter setting, but directly returns to Level II menu
and remains at the current function code.
Here is an example of changing the value of F0-04 to 15.00 Hz.
Figure 3-24 Example of changing the parameter value
F0 1500
PRG
F0-00
00.00
PRG
PRG
ENTER
ENTER
PRG
F0-05
15.00
F0-04
If there is a blinking digit, press
/ / to modify the digit.
To save the
setting
Status parameter
(Default display)
In Level III menu, if the parameter has no blinking digit, it means that the parameter cannot be modied. This may
be because:
•
Such a function code is only readable, such as, servo drive model, actually detected parameter and
running record parameter.
•
Such a function code cannot be modied in the running state and can only be changed at stop.