Inovance IS580 Series - IS580 Advantages and Compliance

Preface IS580 User Manual
- 2 -
Introduction
■
Advantages
Compared with the IS300, the IS580 has improvements in the following aspects:
Improvement Description
More stable pressure The pressure uctuation is smaller. The stability obvious at high pressure and low speed.
Faster pressure and speed
response
The pressure and speed responsiveness improves, satisfying the quick response
requirements of the quick hydraulic IMM.
Higher injection molding
product consistency
The IS580 sees a rise in the qualied rate of the injection moudling products, especially the
quick injection molding products.
Smaller size The IS580 is over 40% smaller than the IS300 for the same power class.
Wide voltage range design Rated voltage input: 380 to 480 V, wide voltage range: 323 to 528 V
Built-in DC reactor The IS580 of 30 kW and above have built-in DC reactor.
Built-in braking unit and
related protective function
The power class of the IS580 with built-in braking unit extends to 75 kW (optional for the
models of 90 kW above). The protective functions including braking resistor short-circuit,
braking circuit overcurrent, brake pipe overload and brake pipe shoot-through.
Longer serving life The bus capacitor has high disposition and long servicing life.
Cooling fan drive circuit
protection
When short-circuit occurs on the cooling fan, the cooling fan drive circuit provides
protection.
Complete protective
functions
The whole series of IS580 drives have the protections on short-circuit to ground and pre-
charge relay (contactor) close fault.
Complete EMC solution Complete EMC solution (including optional EMI lter, common mode rejector / zero-phase
reactor and simple lter) could be provided to satisfy the actual application and certication
requirements.
■
Product Checking
Upon unpacking, check:
•
Whether the nameplate model and the drive ratings are consistent with your order. The box contains the servo
drive, certicate of conformity, user manual and warranty card.
•
Whether the servo drive is damaged during transportation. If you find any omission or damage, contact
Inovance or your supplier immediately.
■
First-time Use
For the users who use this product for the rst time, read the manual carefully. If you have any problem concerning
the functions or performance, contact the technical support personnel of Inovance to ensure correct use.