Inovance IS580 Series - Wiring Mode; Main Circuit Terminals and Wiring

IS580 User Manual Chapter 3 Mechanical and Electrical Installation
- 27 -
3.2 Wiring Mode
The wiring of the IS580 series servo drive is shown in the foldout at the end of this chapter.
3.3 Main Circuit Terminals and Wiring
Figure 3-15 Terminal arrangement of the main circuit
MOTOR POWER
R S T
BR (+) (-)
U V W
Figure 3-16 Wiring mode of the IS580 of three-phase 380 to 480 V
W
V
U
(-)
IS580
MCCB
T
S
R
T
S
R
BR (+)
M
Braking resistor
Three-phase 380/480 V,
50/60Hz
IS580T035-R1-1 to IS580T140-R1-1
W
V
U
(-)
IS580
MCCB
Three-phase 380/480 V,
50/60Hz
T
S
R
T
S
R
(+)
M
Braking resistor
Braking unit
IS580T170-R1-1 to IS580T210-R1-1
The terminals of the main circuit terminals are described in the following table.
Terminal Name Description
R, S, T Three-phase power input terminals Connect to the three-phase power supply.
(+), (-)
Positive and negative
terminals of DC bus
Common DC bus input point.
Connect to the external braking unit for the models of 90 kW and
above.
(+), BR
Terminals for connecting braking
resistor
Connect to a braking resistor for the models of 75 kW and below.
U, V, W Servo drive output terminals Connect to a three-phase motor.
Grounding terminal Must be grounded.