Chapter 3 Mechanical and Electrical Installation IS580 User Manual
- 26 -
3.1.4 Removal of the Front Cover
For the IS580 series servo drives, you need to remove the front cover before wiring the main circuit and control
circuit. The following gures show how to remove the front cover of the IS580.
Figure 3-12 Removal of the front cover of IS580 plastic housing (IS580T020-R1-1 to IS580T070-R1-1)
Hook slot
1. Press inward
symmetrically to
disconnect the hook
from the hook slot.
2.
Catch the edge of
the cover and lift it.
Figure 3-13 Removal of the front cover of IS580 sheet metal housing (IS580T080-R1-1 to IS580T210-R1-1)
1. Loosen the four screws.
2. Remove the cover
toward you.
Figure 3-14 Removal of the front cover of IS580 sheet metal housing (IS580T080-R1-H-1 to IS580T210-R1-H-1)
① Loosen the four screws.
② Remove the cover toward you.
Note
•
Be careful when removing the front cover of the servo drive. Falling off of the cover may cause damage to
the servo drive or personal injury.
To Next Page
Loading...
