- 25 -
5. Embedded mounting of the IS580 of sheet metal housing (IS580T080-R1-H-1 to IS580T210-R1-H-1)
Figure 3-10 Embedded mounting from the cabinet front
Install the servo drive from the
back of the control cabinet
Back panel of the
control cabinet
① Remove the two rings.
② Fix and tighten the 18 M6 screws.
The installation precautions are as follows:
•
Reserve the installation clearances as specified in Figure 3-1 to ensure sufficient space for heat
dissipation. Take heat dissipation of other components in the cabinet into consideration.
•
Install the Servo drives upright to facilitate heat dissipation. If multiple Servo drives are installed in the cabinet,
install them side by side. If one row of Servo drives need to be installed above another row, install an insulation
guide plate, as shown in Figure 3-2.
•
Use the incombustible hanging bracket.
•
In scenarios with heavy metal powder, install the heatsink outside the cabinet, and ensure that the
room inside the fully-sealed cabinet is as large as possible.
To Next Page
Loading...
