- 70 -
No. Symptom Possible Causes Solutions
9 The servo drive
reports overcurrent
and overvoltage faults
frequently.
1. The motor parameters in group F1
are set improperly.
2. The acceleration/deceleration time
is improper.
3. The load uctuates.
1. Set the motor parameters or perform motor
auto-tuning again.
2. Set proper acceleration/deceleration time.3.
Contact the agent or Inovance.
10 Err17 is reported upon
power-on or running.
The soft startup contactor is not
closed.
1. Check:
Whether the contactor cable is loose
Whether the contactor is faulty
Whether the contactor 24 V power supply is
faulty.
2. Contact the agent or Inovance.
To Next Page
Loading...
