MD021 Plastic Wire Drawing Machine User Manual
Digit display Level I menu Level II menu Level III menu
Modify the
parameter group
Modify the
function code
Modify the value of
the function code
In Level III menu, you can modify parameters by pressing ▲ or ▼.
● After the modification, if you press ENTER, the system saves
parameter setting first, and then goes back to Level II menu and shifts
to the next function code.
● After the modification, if you press PRG, the system does not save
parameter setting, but directly returns to Level II menu and stays at the
current function code.
In Level III menu, if the parameter has no blinking bit, it means that
the parameter cannot be modified. This may be because:
● Such function code is readable parameter, such as actually detected
parameter and running record parameter.
● Such function code cannot be modified in the running state and can
only be changed after the inverter stops.
● Such function code is set after inverter auto-tuning and cannot be
modified.
The methods of displaying the status parameter are as follows:
To Next Page
Loading...