Inovance MD280NT2.2GB - Page 129

Description of Function Codes MD280 User Manual
- 128 -
Function Code Parameter Name Setting Range Default
F5-02 JOG deceleration time 0.0–300.0s 20.0s
7KHVHSDUDPHWHUVDUHXVHGWRGH¿QHWKHVHWIUHTXHQF\DQGDFFHOHUDWLRQGHFHOHUDWLRQWLPH
RIWKH$&GULYHZKHQMRJJLQJ7KHVWDUWXSPRGHLV'LUHFWVWDUW)  DQGWKHVWRS
PRGHLV'HFHOHUDWHWRVWRS) GXULQJMRJJLQJ
)-2*DFFHOHUDWLRQWLPHVSHFL¿HVWKHWLPHIRUWKH$&GULYHWRDFFHOHUDWHIURP+]WR
WKHPD[LPXPRXWSXWIUHTXHQF\))-2*GHFHOHUDWLRQWLPHVSHFL¿HVWKHWLPHIRU
WKH$&GULYHWRGHFHOHUDWHIURPWKHPD[LPXPRXWSXWIUHTXHQF\)WR+]
Forward JOG and reverse JOG are valid regardless of the setting of F0-00.
Note that the JOG running frequency is not limited by the frequency lower limit and jump
frequency.
Function Code Parameter Name Setting Range Default
F5-03 JOG during running
0: Disabled
1: Enabled
0
It is used to set whether JOG is allowed during running.
,IWKH-2*IXQFWLRQLV HQDEOHGGXULQJUXQQLQJWKH$&GULYHH[HFXWHVWKHDFWLYH-2*
FRPPDQG¿UVWDQGWKHQUHVWRUHVWRWKHUXQQLQJVWDWHEHIRUHWKH-2*RSHUDWLRQ
Note that this function is disabled during DC braking.
If the PLC is used, it memorizes the running stage and accumulative running time at the
JOG moment. After the JOG operation is completed, the AC drive restores to the running
stage and continues to run for the rest time in this stage.
Function Code Parameter Name Setting Range Default
F5-04 Acceleration time 2 ±VP Model dependent
F5-05 Deceleration time 2 ±VP Model dependent
This group of acceleration/deceleration time is set in the same way as acceleration/
deceleration 1 in F0-09 and F0-10. You can switch over between the four groups of
acceleration/deceleration time through a DI. For more details, see the descriptions of F2-00
to F2-04.
Function Code Parameter Name Setting Range Default
F5-06 Jump frequency +]WRPD[LPXPIUHTXHQF\) 0.00 Hz
F5-07
Frequency jump
amplitude
+]WRPD[LPXPIUHTXHQF\) 0.00 Hz
If the set frequency is within the frequency jump range, the actual running frequency is the
jump frequency close to the set frequency. Setting the jump frequency helps to avoid the
mechanical resonance point of the load.
If the jump frequency is set to 0, the frequency jump function is disabled. The principle of the
MXPSIUHTXHQFLHVDQGMXPSDPSOLWXGHLVVKRZQLQWKHIROORZLQJ¿JXUH
efesotomasyon.com