Inovance MD280NT2.2GB - Page 149

Description of Function Codes MD280 User Manual
- 148 -
Function Code Parameter Name Setting Range Default
FB-15 Time interval of fault auto reset 0.1–60.0s 1.0s
It is used to set the waiting time from the alarm of the AC drive to fault auto reset.
Function Code Parameter Name Setting Range Default
FB-16 Clear time of fault auto reset times 0.1–1000.0 h 1.0 h
:KHQWKHUXQQLQJWLPHRIWKH$&GULYHUHDFKHVWKHYDOXHRIWKLVSDUDPHWHUWKHH[LVWLQJIDXOW
auto reset times is cleared to 0.
Function Code Parameter Name Setting Range Default
FB-17 Input phase loss protection
0: Disabled
1: Enabled
1
Only the MD280 of above 18.6 kW provides the input phase loss function.
Function Code Parameter Name Setting Range Default
FB-18 Output phase loss protection
0: Disabled
1: Enabled
1
It is used to determine whether to perform output phase loss protection.
Function Code Parameter Name Setting Range Default
FB-19 Heatsink temperature of inverter module -10 to 100.0°C -
,WLVXVHGWRGLVSOD\WKHLQVXODWHGJDWHELSRODUWUDQVLVWRU,*%7WHPSHUDWXUHRIWKHLQYHUWHU
module.
Function Code Name Setting Range
FB-20 1st fault type
0–41FB-21 2nd fault type
FB-22 UGODWHVWIDXOWW\SH
These parameters are used to record the types of the most recent three faults of the AC
drive. The value 0 indicates no fault. For possible causes and solution of each fault, refer to
Chapter 8.
Function Code Parameter Name Description
FB-23 Frequency upon 3rd fault
It displays the frequency when the latest fault
occurs.
FB-24 Current upon 3rd fault
It displays the current when the latest fault
occurs.
FB-25 Bus voltage upon 3rd fault
It displays the bus voltage when the latest fault
occurs.
efesotomasyon.com