Inovance MD380-5T5.5GB - Page 100

MD380 User Manual Function Code Table
- 99 -
)unction
Code
Parameter Name
Setting Range
Default Property
)8-05 Acceleration time 3
0.0–6500.0s
Model
dependent
ƿ
)8-06 Deceleration time 3
0.0–6500.0s
Model
dependent
ƿ
)8-07 Acceleration time 4
0.0–500.0s
Model
dependent
ƿ
)8-08 Deceleration time 4
0.0–6500.0s
Model
dependent
ƿ
)8-09 Jump frequency 1
0.00 Hz to maximum frequency
0.00 Hz ƿ
)8-10 Jump frequency 2
0.00 Hz to maximum frequency
0.00 Hz ƿ
)8-11 )requency jump amplitude
0.00 Hz to maximum frequency
0.00 Hz ƿ
)8-12
)orward/Reverse rotation
dead-zone time
0.0–3000.0s
0.0s ƿ
)8-13 Reverse control
0: Enabled
1: Disabled
0 ƿ
)8-14
Running mode when set
frequency lower than
frequency lower limit
0: Run at frequency lower limit
1: Stop
2: Run at zero speed
0 ƿ
)8-15 Droop control
0.00–10.00 Hz
0.00 Hz ƿ
)8-16
Accumulative power-on time
threshold
0–65000 h
0 h ƿ
)8-17
Accumulative running time
threshold
0–65000 h
0 h ƿ
)8-18 Startup protection
0: No
1: Yes
0 ƿ
)8-19
)requency detection value
()DT1)
0.00 Hz to maximum frequency
50.00 Hz ƿ
)8-20
)requency detection
hysteresis ()DT hysteresis 1)
±)'7OHYHO
5.0% ƿ
)8-21
Detection range of frequency
reached
0.00–100% (maximum frequency)
0.0% ƿ
)8-22
Jump frequency during
acceleration/deceleration
0: Disabled1: Enabled
0 ƿ
)8-25
)requency switchover point
between acceleration time 1
and acceleration time 2
0.00 Hz to maximum frequency
0.00 Hz ƿ
)8-26
)requency switchover point
between deceleration time 1
and deceleration time 2
0.00 to maximum frequency
0.00 Hz ƿ
)8-27 Te
rminal JOG preferred
0: Disabled1: Enabled
0 ƿ
efesotomasyon.com