Inovance MD380-5T5.5GB - Group A2 to A4: Motor 2 to Motor 4 Parameters

Description of Function Codes
MD380 User Manual
- 228 -
)unction Code Parameter Name Setting Range Default
A1-21 VDO state selection
Unit's digit (VDO1)
00000
0: Positive logic
1: Reverse logic
Te
n's digit (VDO2)
0, 1 (same as unit's digit)
Hundred's digit (VDO3)
0, 1 (same as unit's digit)
Thousand's digit (VDO4)
0, 1 (same as unit's digit)
Te
n thousand's digit (VDO5)
0, 1 (same as unit's digit)
VDO functions are similar to the DO functions on the control board. The VDO can be used
together with VDIx to implement some simple logic control.
 If VDO function is set to 0, the state of VDO1 to VDO5 is determined by the state of
DI1 to DI5 on the control board. In this case, VDOx and DIx are one-to-one mapping
relationship.
 If VDO function is set to non-0, the function setting and use of VDOx are the same as
'2LQJURXS)
The VDOx state can be set in A1-21. The application examples of VDIx involve the use of
VDOx, and see the examples for your reference.
Group A2 to A4: Motor 2 to Motor 4 Parameters
7KH0'FDQVZLWFKRYHUWKHUXQQLQJDPRQJIRXUPRWRUV)RUWKHIRXUPRWRUV\RXFDQ
 Set motor nameplate parameters respectively
 Perform motor parameter auto-tuning respectively
 6HOHFW9)FRQWURORUYHFWRUFRQWUROUHVSHFWLYHO\
 Set encoder-related parameters respectively
 6HWSDUDPHWHUVUHODWHGWR9)FRQWURORUYHFWRUFRQWUROLQGHSHQGHQWO\
Groups A2, A3 and A4 respectively correspond to motor 2, motor 3 and motor 4. The
parameters of the three groups are the same. Here we just list the parameters of group A2
for reference.
$OOSDUDPHWHUVLQJURXS$KDYHWKHVDPHGH¿QLWLRQDQGXVDJHDVSDUDPHWHUVRIPRWRU
)RUPRUHGHWDLOVUHIHUWRWKHGHVFULSWLRQVRIPRWRUSDUDPHWHUV
)unction Code Parameter Name Setting Range Default
A2-00 Motor type selection
0: Common asynchronous motor
1: Va
riable frequency asynchronous motor
2: Permanent magnetic synchronous motor
0
efesotomasyon.com