Inovance MD380-5T5.5GB - Group 7: Operation Panel and Display

MD380 User Manual Desc
ription of Function Codes
- 183 -
Group )7: Operation Panel and Display
)unction Code Parameter Name Setting Range Default
)7-01
M).
K Key function
selection
0: M).
K key disabled
1: Switchover between operation panel
control and remote command control
(terminal or communication)
2: Switchover between forward rotation
and reverse rotation
3: )orward JOG
4: Reverse JOG
0
0).NH\UHIHUVWRPXOWLIXQFWLRQDONH\<RXFDQVHWWKHIXQFWLRQRIWKH0).NH\E\XVLQJWKLV
parameter. You can perform switchover by using this key both in stop or running state.
 0).NH\GLVDEOHG
This key is disabled.
 1: Switchover between operation panel control and remote command control (terminal
or communication)
You can perform switchover from the current command source to the operation panel
control (local operation). If the current command source is operation panel control, this
key is invalid.
 2: Switchover between forward rotation and reverse rotation
<RXFDQFKDQJHWKHGLUHFWLRQRIWKHIUHTXHQF\UHIHUHQFHE\XVLQJWKH0).NH\,WLV
valid only when the current command source is operation panel control.
 )RUZDUG-2*
<RXFDQSHUIRUPIRUZDUG-2*)-2*E\XVLQJWKH0).NH\
 4: Reverse JOG
<RXFDQSHUIRUPUHYHUVH-2*)-2*E\XVLQJWKH0).NH\
)unction Code Parameter Name Setting Range Default
)7-02
STO
P/RESET key
function
0: STOP/RESET key enabled only in
operation panel control
1: STO
P/RESET key enabled in any
operation mode
1
efesotomasyon.com