Inovance MD380-5T5.5GB - Page 192

MD380 User Manual Desc
ription of Function Codes
- 191 -
These two parameters are respectively used to set the detection value of output frequency
DQGK\VWHUHVLVYDOXHXSRQFDQFHOODWLRQRIWKHRXWSXW7KHYDOXHRI)LVDSHUFHQWDJHRI
WKHK\VWHUHVLVIUHTXHQF\WRWKHIUHTXHQF\GHWHFWLRQYDOXH)
7KH)'7IXQFWLRQLVVKRZQLQWKHIROORZLQJ¿JXUH
)LJXUH)'7OHYHO
Time (t)
Output frequency (Hz)
)'7OHYHO
)'7K\VWHUHVLV
= )8-19 [)8-20
Time (t)
)UHTXHQF\UHDFKHG
detection signal
(DO, relay)
ON
)unction Code Parameter Name Setting Range Default
)8-21
Detection range of frequency
reached
0.00–100% (maximum
frequency)
0.0%
If the AC drive running frequency is within the certain range of the set frequency, the
corresponding DO terminal becomes ON.
This parameter is used to set the range within which the output frequency is detected
to reach the set frequency. The value of this parameter is a percentage relative to the
maximum frequency. The detection range of frequency reached is shown in the following
¿JXUH
)LJXUH'HWHFWLRQUDQJHRIIUHTXHQF\UHDFKHG
Time (t)
Output frequency (Hz)
Set frequency
Detection
range
)UHTXHQF\UHDFKHG
detection signal
ON ON
efesotomasyon.com