Inovance MD380-5T5.5GB - Page 194

MD380 User Manual Desc
ription of Function Codes
- 193 -
)LJXUH$FFHOHUDWLRQGHFHOHUDWLRQWLPHVZLWFKRYHU
Output
frequency (Hz)
Set frequency
)8-25
)8-26
Acceleration
time 2
Acceleration
time 1
Deceleration
time 1
Deceleration
time 2
Time (t)
'XULQJDFFHOHUDWLRQLIWKHUXQQLQJIUHTXHQF\LVVPDOOHUWKDQWKHYDOXHRI)DFFHOHUDWLRQ
WLPHLVVHOHFWHG,IWKHUXQQLQJIUHTXHQF\LVODUJHUWKDQWKHYDOXHRI)DFFHOHUDWLRQ
time 1 is selected.
'XULQJGHFHOHUDWLRQLIWKHUXQQLQJIUHTXHQF\LVODUJHUWKDQWKHYDOXHRI)GHFHOHUDWLRQ
WLPHLVVHOHFWHG,IWKHUXQQLQJIUHTXHQF\LVVPDOOHUWKDQWKHYDOXHRI)GHFHOHUDWLRQ
time 2 is selected.
)unction Code Parameter Name Setting Range Default
)8-27 Terminal JOG preferred
0: Disabled
1: Enabled
0
It is used to set whether terminal JOG is preferred.
If terminal JOG is preferred, the AC drive switches to terminal JOG running state when there
is a terminal JOG command during the running process of the AC drive.
)unction Code Parameter Name Setting Range Default
)8-28 )requency detection value ()DT2)
0.00 to maximum
frequency
50.00 Hz
)8-29
)requency detection hysteresis
()DT
hysteresis 2)
0.0%–100.0% ()DT2
level)
5.0%
7KHIUHTXHQF\GHWHFWLRQIXQFWLRQLVWKHVDPHDV)'7IXQFWLRQ)RUGHWDLOVUHIHUWRWKH
GHVFULSWLRQVRI)DQG)
)unction Code Parameter Name Setting Range Default
)8-30
Any frequency reaching
detection value 1
0.00 Hz to maximum
frequency
50.00 Hz
)8-31
Any frequency reaching
detection amplitude 1
0.0%–100.0% (maximum
frequency)
0.0%
)8-32
Any frequency reaching
detection value 2
0.00 Hz to maximum
frequency
50.00 Hz
efesotomasyon.com