Inovance MD380-5T5.5GB - Page 57

Operation, Display and Application Examples MD380 User Manual
- 56 -
 2: Communication control
7KHPRVWFRPPRQFRQ¿JXUDWLRQLVZKHQWKHKRVWFRPSXWHULVXVHGWRFRQWUROUXQQLQJ
RIWKH$&GULYHE\PHDQVRIFRPPXQLFDWLRQVXFKDVWKH 56 352),%86'3
CANlink, and CANopen. The MD380 interacts with the user programmable card also by
means of communication.
,QVWDOODPDWFKLQJFRPPXQLFDWLRQFDUGLQWKHPXOWLIXQFWLRQH[WHQVLRQSRUWDQGVHW)
02 to 2. Then, you can start or stop the AC drive in communication mode. The following
¿JXUHVKRZVWKHVHWWLQJPHWKRG
)LJXUH6HWWLQJIRUVWDUWVWRSXVLQJWKHFRPPXQLFDWLRQFRQWUROPRGH
)4-00
)4-01
)4-02
)4-03
)4-04
.
.
1
2
.
.
)0-02 = 1
Running
command
)4-11 = 0
Control switch
Terminal
)XQFWL RQ
code
Setting
value
Terminal
control
DI1
DI2
DI3
DI4
DI5
.
COM
RUN/
)RUZDUG
)RUZDUG581
Terminal control
Command source
selection
Two-line mode 1
RUN/
Reverse
Reverse RUN
SW2
SW1
:KHQ)'LVVHWWRDQRQ]HURQXPEHUWKHIXQFWLRQRIDXWRPDWLF$&GULYHVWRSXSRQ
communication timeout is enabled. This prevents uncontrollable AC drive running due
to faults of the communication cable or the host computer.
The communication port of the AC drive supports the Modbus-RTU protocol, and the
communication is implemented only when the host computer supports the Modbus-
RTU master station protocol.
4.7.2 Start Mode
The MD380 supports three start modes, namely, direct start, rotational speed tracking
UHVWDUWDQGSUHH[FLWHGVWDUWDV\QFKURQRXVPRWRUVHWLQ)
 ) GLUHFWVWDUW
It is applicable to small-inertia load. The frequency curve in this mode is shown in the
IROORZLQJ¿JXUH
DC braking before the start is applicable to drive of load such as elevator and crane.
Startup frequency is applicable to drive with burst start under start torque, such as
cement mixer.
efesotomasyon.com