Product Information
‑34‑
2.4 Basic Specifications
Item
Description
Basic
Specifica
tions
Control mode
IGBT PWM control, sine wave current
drive mode
220 V, 380 V: Single‑phase/Three‑phase
full bridge rectification
Encoder feedback
23‑bit multi‑turn absolute encoder, which
can be used as an incremental encoder in
absence of the battery
Work
ing
Condi
tion
Operating/Storage
temperature
[1]
0℃ to +55℃ (If the ambient temperature
exceeds 45℃, derate by 10% for every
additional 5℃)/ ‑20℃ to +70℃
Operating/Storage
humidity
Below 90% RH (no condensation)
Vibration resistance
4.9m/s
2
Impact resistance
19.6m/s
2
IP rating
IP20 (excluding terminals (IP00))
Pollution degree
PD2
Altitude
Max. 5000 m
For altitudes not higher than 1000 m,
derating is not required.
Derating is required for altitudes above
1000 m (derate 1% for every additional
100 m).
For altitudes above 2000 m, contact
Inovance.
Note
[1] The temperature of the environment where the servo drive is installed must be within
the range specified in the preceding table. When the servo drive is installed into a control
cabinet, the temperature inside the cabinet must also be within this range.
To Next Page
Loading...
