Keypad
‑68‑
Figure 5‑8 DI level status corresponding to H0b.03
■ Exit
The forced DI signal function is not retentive upon power‑off. Normal DIs apply
after restart, or you can set H0d.17 to 0 (No operation) to return to the normal
DI mode.
● Forced DO function
After this function is enabled, all DO signal levels are controlled by H0d.19 (Forced
DO value), regardless of the internal DO status of the servo drive.
If the motor is used in vertical motion, when the brake output signal is set to Enabled, the
brake will open and the load may fall. Take protective measures on the machine to prevent
the risk of falling.
■ Operating process
To Next Page
Loading...
