8
INOVANCE TECHNOLGY EUROPE GmbH
SV660N Startup Procedure_EN_v1.4_20220826.docx
• Communication: Serial port
• Baud Rate: 115200
• Data bit:8
• Check bit: none
• Stop bit: 1
Select the corresponding drive model (in this case SV660N) and click “Next Page” button.
The next image shows the dialog for scanning drives:
1. When the dialog opens, the scan of the devices starts automatically. But using this buttons it is
possible to start and stop the scanning procedure.
2. In this text box there is the range node Id to search devices. Usually the drive uses no Id 1
3. When a device is detected it is shown in this list.
4. This message shows when the search ends
5. Name of the project
6. Folder where project is stored
Select the SV660N Drive which connected on the serial port communication and define the project name then
press the button “Finish”
To Next Page
Loading...
