11
NS-OTRC15SS9
www.insigniaproducts.com
7 Drill holes through the template at points A, B, and C or D. If the hole lines up with a stud, drill a 3/16” hole. Otherwise,
drill a 5/8” hole for the toggle bolts. You must use at least three holes for mounting.
You’ll need:
Note: Depending on your stud locations, your installation may look
different. You must mount to at least one stud.
Rear wall template
Pencil
Duct tape
Electric drill with 3/16” and 5/8” bits
Level
Ruler or tape measure
To Next Page
Loading...
