Insignia NS-OTRC15SS9 Installation Guide

www.insigniaproducts.com
22
1.5 Cu. Ft. Over-the-Range Convection Microwave
Step 4: Option B - Cutting a vent opening
1 Use a saber or keyhole saw to cut out the shaded area K through the rear wall.
2 Remove the rear wall template.
Note: If a wall stud is within 6 in. (15.2 cm) of the vertical center line, you cannot use this installation option.
You’ll need:
Saw
Saw
(saber, hole, or keyhole)

Insignia NS-OTRC15SS9 Specifications

General

Brand	Insignia
Model	NS-OTRC15SS9
Category	Microwave Oven
Language	English