Insignia NS-OTRC15SS9 - Cookware and Cooking Materials; Materials You Can Use; Materials to Avoid

5
NS-OTRC15SS9
www.insigniaproducts.com
Before you install
Read these instructions completely before installing your microwave. Make sure that your space meets the mounting
requirements and that you’ve gathered all needed tools and materials.
Tools and materials needed
#1 Phillips screwdriver
Pencil
Tin snips
(to cut damper, if needed)
Scissors
(to cut template, if needed)
Gloves
Safety goggles
Saw
(saber, hole, or keyhole)
Ruler or tape measure
Electric drill with 3/16”, 1/2”, and 5/8” bits
Edge-to-edge stud finder
Level
Duct tape
Filler blocks or scrap wood pieces
(for top cabinet spacing in recessed
bottom cabinet installations, if needed)
Carpenter square
(optional)
Ducts (if venting outside)
See “
Exhaust requirements” on page 7