www.insigniaproducts.com
16
1.5 Cu. Ft. Over-the-Range Convection Microwave
10 If you have recessed cabinets:
• Make two filler blocks out of scrap wood pieces the size of shaded areas H (about 2.25 × 4.125 in. or 5.7 × 10.5 cm).
They must be as thick as the depth of the cabinet recess.
• Drill 5/8" holes in the filler blocks to align with points A and B.
• Align the blocks with the corresponding holes in the cabinet. They should be at the same level as the bottom edge of
the cabinet frame.
11 Remove the template.
You’ll need:
Electric drill with 1/2” and
5/8” bits
Duct tape
Scissors
(recessed cabinets only)
Safety goggles
Saw
(saber, hole, or keyhole)
Ruler or tape measure
Filler blocks or scrap wood pieces
(for recessed cabinets only)
Top Cabinet Template
To Next Page
Loading...
Need help?
General
