Insignia NS-OTRC15SS9 - Page 33

33
NS-OTRC15SS9
www.insigniaproducts.com
5 Insert wood screw(s) through the mounting plate and into the hole(s) drilled in the stud(s), then tighten both the wood
screw(s) and toggle bolt(s) with a Phillips screwdriver to mount the plate. Make sure that the plate is centered before
tightening fully.
Caution: Be careful to avoid pinching your fingers between the back of the mounting plate and the wall.
You’ll need:
Mounting plate
Wall
Toggle wing
Toggle bolt
Wood screws
Mounting plate
(ships attached to microwave)
Phillips screwdrivers
Toggle bolts