Instant Pot Pro Plus 60 User Manual

50 | support@instantpot.com | 1-800-828-7280
Troubleshooting
Problem Possible reason Try this
Steam leaks
from the side
of the lid.
No sealing ring in the lid. Install a sealing ring.
The sealing ring is damaged or
not installed properly.
Replace the sealing ring.
Food debris on to the
sealing ring.
Remove the sealing ring and clean it thoroughly.
The lid is not closed properly. Open, then close the lid.
The sealing ring rack is warped
or off-center.
Remove the sealing ring from the lid, then check the
sealing ring rack for bends or warps. Contact Customer
Care.
The inner pot rim may be
misshapen.
Check for deformation and contact Customer Care.
The float valve
does not rise.
Food debris on the oat valve
or oat valve silicone cap.
Remove the oat valve from the lid and clean it thoroughly.
Perform the Initial test run to check for function and record
your ndings. Contact Customer Care.
Too little liquid in the inner pot.
Check for scorching on the bottom of the inner pot. Add
thin, water-based liquid to the inner pot according to its
size.
8 Qt: 2 cups (500 mL / ~16 oz)
Float valve silicone cap
damaged or missing.
Install or replace the oat valve and/or silicone cap.
Float valve obstructed by lid-
locking mechanism.
Tap the oat valve with a long utensil. If the oat valve does
not drop, turn the multicooker off. Contact Customer Care.
No heat in the inner pot.
Perform the Initial test run to check for function and record
your ndings. Contact Customer Care.
Inner pot base may be
damaged.
Perform the Initial test run to check for function and record
your ndings. Contact Customer Care.
Minor steam
leaking or
hissing from
the steam
release
valve during
Cooking.
Quick release switch is not in
the Seal position.
Move the quick release switch into the Seal position.
The multicooker is regulating
excess pressure.
This is normal; no action required.
Steam gushes
from the steam
release valve
while the quick
release switch
is in the Seal
position.
Not enough liquid in the inner
pot.
Add thin, water-based liquid to the inner pot according to
its size.
8 Qt: 2 cups (500 mL / ~16 oz)
Pressure sensor control failure. Contact Customer Care.
Steam release valve is not
seated properly.
Release pressure, then make sure the steam release valve
is installed properly. See Care, cleaning and storage:
Removing and installing parts.

Instant Pot Pro Plus 60 Specifications

General

Brand	Instant Pot
Model	Pro Plus 60
Category	Electric Pressure Cooker
Language	English