3-7
Installing and Removing Jaw Faces
Installation
5. To expose the mounting face slot and the dowel pin hole, use a small probe to
push in on the right hand grip shaft.
6. Insert the dowel pin into the hole in the shaft until it is flush with the inside of
the slot. Move the jaw face into position by inserting it through the
rectangular slot in the frame that faces the main portion of the grip.
7. Insert the dowel pin.
8. Push in on the face to check that the shaft moves freely in the grip.
Removing Jaw faces
1. Push inward on the right hand face to expose a horizontal dowel pin, which
holds the face to the shaft.
2. Use a small probe to push out the dowel pin.
3. Remove the face by moving it toward the main body of the grip through the
slot in the frame.
4. Push inward on the left hand face to expose the vertical dowel pin.
5. Push out the pin and remove the face.
To Next Page
Loading...