5-5
Servicing
Maintenance
Servicing
Review the following list before you service a grip:
Contact Instron Service regarding warranty and repair services.
Before you disassemble the clamps for cleaning or servicing, refer to the
drawings in Chapter 6.
Remove the jaw faces before you service the grips, except for the 2712-001
and 2712-013 grips.
When assembling the toggle air valve, check that the slot in the ball is
positioned facing the center of the grip. Do not place the ball with the slot
facing to either side, because the grip will not open or close with an
incorrectly positioned ball valve.
To Next Page
Loading...
Need help?
General