43
Playing Your AV Components
Basic AV Receiver Operation
3
1
3
1
1
Use the AV receiver’s input selector buttons to select an input source.
To select an input source with the remote controller, press its Input Selec-
tor buttons.
To listen to a DVD player connected to the multichannel DVD input (page 23), press
the AV receiver’s [Multi CH] button. The MULTI CH indicator will appear on the dis-
play.
Note:
• While the multichannel DVD input is selected, the Speaker Configuration settings on
page 35 are ignored, and signals from the multichannel input are fed to the speakers
as they are.
2
Start playback on the source component.
To watch a DVD or other video source, on your TV, select the video input that’s con-
nected to the AV receiver’s COMPONENT VIDEO OUT, HDMI OUT, or MONITOR
OUT.
On some DVD players, you may need to change the digital or HDMI audio output
settings.
3
To adjust the volume, use the Master Volume control or the remote con-
troller’s [VOL] button.
Since the AV receiver is designed for home theaters, it has a wide volume range for
precise adjustment. The volume can be set to Min, 1 through 79, or Max.
The maximum volume level can be limited with the MaxVolume setting. See “Volume
Setup” on page 62.
4
Select a listening mode and enjoy!
See “Using the Listening Modes” on page 50.
Remote
controller
AV receiver
Remote
controller
AV receiver
DTR-4.9En.book Page 43 Tuesday, April 15, 2008 5:13 PM
To Next Page
Loading...
Need help?
General
