To Next Page
C
Christopher JonesSep 2, 2025
What to do if I press the on button on the remote controller, but the Integra DTR-5.1 Receiver doesn't turn on?
- AAngela FoxSep 2, 2025
Make sure to press the MODE AUDIO button first, and then press the ON button.
What to do if I press the on button on the remote controller, but the Integra DTR-5.1 Receiver doesn't turn on?
Make sure to press the MODE AUDIO button first, and then press the ON button.
What to do if I can't receive AM stations on my Integra DTR-5.1 Receiver?
Ensure that the included AM loop antenna is connected to the AM antenna terminals.
Why is there hum or low-frequency noise coming from my Integra DTR-5.1 Receiver?
This could be due to a poor or missing input ground, so check the outer conductor of the input plugs. Also, inspect the phono motor ground for a proper connection. Adjust the placement of the audio connection cables on the rear panel to potentially reduce the hum.
What to do if the front panel controls on my Integra Receiver work, but the remote controller doesn't?
First, check if there are batteries in the remote controller and insert them if missing. If batteries are present, try replacing them, as they may be worn out.
What to do if my Integra DTR-5.1 has no power?
First, ensure the power cord is properly connected. If it is, try turning the power off and on again, or unplug the AC cord from the outlet, wait a few seconds, and plug it back in. If the issue persists, it might be due to a blown AC fuse, in which case you should contact your Integra/Onkyo authorized Service Center.
Why is the sound of the playback source not heard on my Integra Receiver?
Ensure that the input selector is properly set to the playback source.
Why is there no sound or very minimal sound from the center speaker on my Integra Receiver?
First, check the connection between the amplifier and the speaker. Ensure that the listening mode is not set to ORCHESTRA or STEREO; if it is, switch to another mode. Also, verify that the CENTER level is not set to minimum and that the CENTER SPEAKER setting is not set to NONE; if it is, set it to LARGE or SMALL.
Covers fire, electric shock, moisture, ventilation, heat, and power safety measures.
Instructions for use, cleaning, servicing, and general appliance care.
Setting parameters for subwoofer, front, center, and surround speakers.
Adjusting speaker distances and finalising sizes for center/surround.
Guide to calibrating speaker levels using the test tone feature.
Setting speaker levels for Multi CH Input and configuring power-on volume.
Details on specific mode parameters like Late Night, Front Effect, Re-EQ, and LFE.
Step-by-step instructions for saving radio frequencies to memory.
Step-by-step guide to teaching the remote new commands.
Procedures for removing learned codes from individual buttons and modes.
Explains macros and provides steps for setting them up.
Procedure for erasing all programmed codes and macros.
Guide to creating single-button sequences for direct device control.
How to remove programmed sequences from MACRO MODE and DIRECT.
Solutions for common problems with the remote, audio, noise, and signal reception.
Identification and explanation of the receiver's front panel elements.
General| Channels | 5.1 |
|---|---|
| Total Harmonic Distortion (THD) | 0.08% |
| Input Impedance | 47 kOhms |
| Audio Formats Supported | Dolby Digital, DTS, Dolby Pro Logic II |
| Video Formats Supported | Composite, S-Video |
| Input Sensitivity | 200 mV |
| Signal-to-Noise Ratio | 100 dB |
| Digital Inputs | 2 Optical, 1 Coaxial |
| Frequency Response | 10Hz - 100kHz |
| Speaker Impedance | 8 ohms |
| Audio Inputs | 5 Analog |
