90
Controlling Other Components
You can use the AV receiver’s remote controller
(RC-683M) to control your other AV components,
including those made by other manufacturers. This sec-
tion explains how to enter the necessary remote control
code for the component that you want to control (e.g.,
DVD player, TV, or VCR).
To control another component, you must first enter the
appropriate remote control code to a Remote Mode but-
ton. You’ll need to enter a code for each component that
you want to control.
Notes:
• A remote control code cannot be entered for the
[Receiver] Remote Mode button.
• The remote control codes provided are correct at the
time of printing, but are subject to change.
Entering Remote Control Codes
1
Look up the appropriate remote
control code in the separate
Remote Control Codes list.
The codes are organized by category
(e.g., DVD player, TV, etc.).
Remote
Mode
Receiver
Display
L Night
Number
buttons
2
While holding down the Remote
Mode button that you want to set,
press the [Display] button for 3
seconds.
The Remote Mode button lights up.
3
Within 30 seconds, use the num-
ber buttons to enter the 4-digit
remote control code.
The Remote Mode button flashes
twice.
4
Press the Remote Mode button
again to select the remote con-
troller mode, point the remote
controller at the component, and
check the operation.
If the remote controller doesn’t work as
expected, and several remote codes are
listed, try each one in turn and use the
one that works best.
To Next Page
Loading...
Need help?
General
