Intek KT-355EE - Accessing Stored Frequencies; Methods for Recalling Memory Frequencies; Memory Recall Example and Advice

Calling up memory frequencies
n Memory (number) frequencres tan be called up usrng any
of the followrng three methods.
(1) Inputting the memory address drrectly usrng the
numeric keys
(2) Callrng up a frequency usrng the rotary channel selector
(3) Callrng up a frequency usrng the A iV keys
(1) Inputting the memory address directly using the
numeric keys
m Calltng up MO7
1) In the VFO mode. press the B VIM ENT key.
The memory mode IS actrvated and the memory address
which was used last appears on the display.
(When the memory mode IS actrvated for the frrst time,
MO0 IS displayed )
2) Press the 0 SET/SB key
MO is displayed.
3) Press the 7 T SQL/DM key.
A peep (long high pitched beep) Sounds to rndrcate that
memory address number 7 has been called up
(Lang high ptfched beep)
‘-1 To call up M26, you would press the 2 DUAL key
followed by the 6 F.L key
(1) The M rndication may Start to flash on and off when you
cal1 up a memory address number.
This Indicates that no frequency is currently assigned to
the memory address number you have selected
(in the following pages. memory address numbers to whrch
no frequencres have been assigned are referred to as
“free memory address numbers.“)
(2) If a free memory address number IS called up, the VFO fre-
quency is displayed.
31