Intek KT-355EE - Power Management and Control Flexibility; Recovering from Auto Power Off Status; Rotary Selector Use with Frequency Lock

Recovering from auto power off Status
n After auto power off IS triggered. the display goes blank
To cancel this Status (return to normal operatlng Status)
elther press one of the 0 - 9 or A - F keys, or swtch
power off and then back on again
Auto power off reduces current consumptmn to the m,ni-
mum level. However, as current IS st/// fiowing through a
port!on of the electronvz orcultry. auto power off Status IS
not really equlvalent to swltch~ng the power oft manuaily
To turn the unit completely off. use the power swtch
Function allowing use of the rotary
channel selector even ‘when frequency
leck is turned on
n Many of the Operation keys are disabled when frequency
leck IS on This function allows use of the rotary channel
selector even when frequency leck IS actlve
1) Swtch to the set mode
2) Press the 6 F L key
Now the rotary channel selector wll still work even if
frequency leck IS turned on
3) To cancel thts function. again switch to the set mode
and press the 6 F L key A puff (short low pitched beep)
Sounds Indicating that the function IS off
If the above Operation 1s performed when the unlt IS ,n the
frequency leck mode. a boo (lang medfum pltched beepj
Sounds and the functlon is not actfvated Turn frequency
leck off before using th1.s function
50