Paging function for
slow-access
repeater stations
n
This
function Increases the Interval between when the PTT
swltch
IS
pressed and when fhe paging
Signal
IS
transmlt-
ted from 400 to 700 msec.
1)
Swatch
to the set mode
2) Press the 3 SFT key
A
Pep
(short high pitched beep)
Sounds,
Indicating that
the Interval has been Increased to 700 msec
3) To restore the Interval to 400 msec.,
again
swltch
to the
set mode and press the 3 SFT key.
A puff (short low pitched beep)
Sounds.
Indicating that
the Interval
IS
now 400 msec. There
IS
no display
mdica-
tion
assoclated with this function
(1)
It
is
not possible
to
tonfirm
whether this function is on or
Off
by lookrng at the o’ispfay.
(2) When this function
IS
on. current consumption lncreases
slightly
Auto power off (APO) function
n
Thts
functton prevents the batterles from being discharged
should you forget to swltch the power
Off
after
usmg
the
unit.
n When this function
IS
actlve, a
pip-plp-plp-Pep
warnmg
(repeated high pitched beeps)
Sounds
if the
unit
IS
left
unattended for apprtiximately 30
mlnutes.
n Approximately one minute after the warning Sounds. nearly
all
powe<
IS
tut
off automatically
Thts
functlon
IS
called auto oower off
(APO)
-
1)
Switch
to the set mode
Function
for suppressing the pop noise
when
squelch
opens
2) Press the 5 SAVE key An AP appears on the display
lndicatlng that auto power off (APO)
IS
on
1-1
SS
1)
Swatch
to the set mode
2) Press the 4 STEP key
A
Pep
(short
high
pltched beep)
Sounds.
Indicating that
the functlon
IS
on.
3) To cancel this function.
again
switch
to the set mode
and press the 4 STEP key
A puff (short
low
pitched beep)
Sounds.
lnd\cating that
the function
IS
off
3) To cancel auto power off, again
switch
to the set mode
and press the 5 SAVE key. The AP dlsappears from the
display and auto power off
IS
canceled
49
To Next Page
Loading...
