Intel Ethernet X520 10GbE Dual Port KX4 Mezz User Manual

Event
ID
Message Severity
41 E1express:
Driver has been stopped.
Informational
42 E1express:
Driver had been started.
Informational
Below is a list of Intel network adapter custom event messages that appear in the Windows* Event Log for the following
adapters:
l
Intel® Gigabit ET Dual Port Server Adapter
l
Intel® Gigabit ET Quad Port Server Adapter
l
Intel® Gigabit ET Mezzanine Card
l
Intel® Gigabit 2P I350-t Adapter
l
Intel® Gigabit 4P I350-t Adapter
l
Intel® Gigabit 4P I350-t rNDC
l
Intel® Gigabit 4P X540/I350 rNDC
l
Intel® Gigabit 4P I350-t Mezz
l
Intel® Gigabit 2P I350-t LOM
l
Intel® Gigabit 4P I350 bNDC
l
Intel® Gigabit 2P I350 LOM
Event
ID
Message Severity
6 PROBLEM: Unable to allocate the map registers necessary for operation.
ACTION: Reduce the number of transmit descriptors and restart.
Error
7 PROBLEM: Could not assign an interrupt for the network adapter.
ACTION: Try a different PCIe slot.
ACTION: Install the latest driver from
http://www.in-
tel.com/support/go/network/adapter/home.htm.
Error
23 PROBLEM: The EEPROM on the network adapter may be corrupt.
ACTION: Visit the support web site at
http://www.in-
tel.com/support/go/network/adapter/home.htm
.
Error
24 PROBLEM: Unable to start the network adapter.
ACTION: Install the latest driver from
http://www.in-
tel.com/support/go/network/adapter/home.htm
.
Error
25 PROBLEM: The MAC address on the network adapter is invalid.
ACTION: Visit
http://www.intel.com/support/go/network/adapter/home.htm
for assistance.
Error
27 Network link has been disconnected. Warning
30 PROBLEM: The network adapter is configured for auto-negotiation but the link partner is not.
This may result in a duplex mismatch.
ACTION: Configure the link partner for auto-negotiation.
Warning
31 Network link has been established at 10Gbps full duplex. Informational
32 Network link has been established at 1Gbps full duplex. Informational
33 Network link has been established at 100Mbps full duplex. Informational
34 Network link has been established at 100Mbps half duplex. Informational
35 Network link has been established at 10Mbps full duplex. Informational

Intel Ethernet X520 10GbE Dual Port KX4 Mezz Specifications

General

Interface	KX4
Data Rate	10 Gbps
Form Factor	Mezzanine
Data Transfer Rate	10 Gbps
Product Type	Network Adapter
Controller	Intel 82599
PCIe Version	2.0
Virtualization	Yes
Operating Temperature	0°C to 55°C
Jumbo Frames	Supported
Ports	Dual Port