[Microsoft-Windows-Shell-Setup\AutoLogon]
Enabled = true
LogonCount = 5
Username = Administrator
[Microsoft-Windows-Shell-Setup\AutoLogon\Password]
<strongpassword>
[Microsoft-Windows-Shell-Setup\FirstLogonCommands]
Description= Begins silent unattended install of Intel PROSet for Windows Device Manager
Order= 1
CommandLine= %systemdrive%\WMIScr\Install.bat
Command Line Installation for Base Drivers and Intel® PROSet
Driver Installation
The driver install utility setup.exe allows unattended installation of drivers from a command line.
These utilities can be used to install the base driver, intermediate driver, and all management applications for sup-
ported devices.
NOTE: You must run setup.exe in a DOS Window in Windows Server 2008. Setup.exe will not run on a com-
puter booted to DOS.
Setup.exe Command Line Options
By setting the parameters in the command line, you can enable and disable management applications. If parameters
are not specified, only existing components are updated.
Setup.exe supports the following command line parameters:
Parameter Definition
BD Base Driver
"0", do not install the base driver.
"1", install the base driver (default).
ANS Advanced Network Services
"0", do not install ANS (default). If ANS is already installed, it will be uninstalled.
"1", install ANS. The ANS property requires DMIX=1.
NOTE: If the ANS parameter is set to ANS=1, both Intel PROSet and ANS will be installed.
DMIX PROSet for Windows Device Manager
"0", do not install Intel PROSet feature (default). If the Intel PROSet feature is already installed, it will be
uninstalled.
"1", install Intel PROSet feature. The DMIX property requires BD=1.
NOTE: If DMIX=0, ANS will not be installed. If DMIX=0 and Intel PROSet, ANS, SMASHv2 and
FCoE are already installed, Intel PROSet, ANS, SMASHv2 and FCoE will be uninstalled.
To Next Page
Loading...
Need help?
General
