Intel Ethernet X520 10GbE Dual Port KX4 Mezz User Manual

Event
ID
Message Severity
53 Jumbo Frames cannot be configured when MACSec is enabled.
NOTE: This message is used only for the following adapters:
l
Intel® Gigabit 2P I350-t Adapter
l
Intel® Gigabit 4P I350-t Adapter
l
Intel® Gigabit 4P I350-t rNDC
l
Intel® Gigabit 4P I350-t Mezz
l
Intel® Gigabit 2P I350 LOM
l
Intel® Gigabit 2P I350-t LOM
Informational
54 PROBLEM: A malicious VF driver has been detected. Warning
55 The value of NumVFs exceeds the maximum value allowed by the driver in the current con-
figuration. The value will be set to the maximum allowed.
Informational
Below is a list of Intel network adapter custom event messages that appear in the Windows Event Log for the Intel 10
Gigabit adapters:
Event
ID
Message Severity
6 PROBLEM: Unable to allocate the map registers necessary for operation.
ACTION: Reduce the number of transmit descriptors and restart.
Error
7 PROBLEM: Could not assign an interrupt for the network adapter.
ACTION: Try another PCI slot.
ACTION: Install the latest driver from
http://www.in-
tel.com/support/go/network/adapter/home.htm
.
Error
23 PROBLEM: The EEPROM on the network adapter may be corrupt.
ACTION: Visit the support web site at
http://www.in-
tel.com/support/go/network/adapter/home.htm
for assistance for assistance.
Error
24 PROBLEM: Unable to start the network adapter.
ACTION: Install the latest driver from
http://www.in-
tel.com/support/go/network/adapter/home.htm
.
Error
25 PROBLEM: The MAC address on the network adapter is invalid.
ACTION: Visit
http://www.intel.com/support/go/network/adapter/home.htm
for assistance.
Error
27 Link has been disconnected. Warning
30 PROBLEM: The network adapter is configured for auto-negotiation but the link partner is not.
This may result in a duplex mismatch.
ACTION: Configure the link partner for auto-negotiation.
Warning
31 Network link has been established at 10Gbps full duplex. Informational
32 Network link has been established at 1Gbps full duplex. Informational
33 Network link has been established at 100Mbps full duplex. Informational
34 Network link has been established at 100Mbps half duplex. Informational
35 Network link has been established at 10Mbps full duplex. Informational
36 Network link has been established at 10Mbps half duplex. Informational
37 PROBLEM: PCI Express bandwidth available for this adapter is not sufficient for optimal per-
formance.
ACTION: Move the adapter to a x8 PCI Express slot.
Warning

Intel Ethernet X520 10GbE Dual Port KX4 Mezz Specifications

General

Interface	KX4
Data Rate	10 Gbps
Form Factor	Mezzanine
Data Transfer Rate	10 Gbps
Product Type	Network Adapter
Controller	Intel 82599
PCIe Version	2.0
Virtualization	Yes
Operating Temperature	0°C to 55°C
Jumbo Frames	Supported
Ports	Dual Port