Intel® Server S2600WF Product Family Configuration Guide
19
1.1.2 Memory Support
The Intel® Server Board S2600WF product family has support for the following memory:
• Registered DDR4 (RDIMM), Load Reduced DDR4 (LRDIMM)
• Memory data transfer rates (Processor dependent. See Table 1, Table 2, and Table 3.)
o DDR4 ECC RDIMM up to 2933 MT/s
o DDR4 ECC LRDIMM up to 2933 MT/s
o DDR4-compatible DDDC Intel® Optane™ DC persistent memory module up to 2666 MT/s
• DDR4 standard voltage of 1.2 V
Note: Intel® Optane™ DC persistent memory module is supported only by Intel® Server Boards S2600WFTR, S2600WF0R, and S2600WFQR with a 2
nd
Gen Intel® Xeon® Scalable processor.
The Intel® Server Board S2600WFTF product family has support for the following memory:
• Registered DDR4 (RDIMM), Load Reduced DDR4 (LRDIMM)
• Memory data transfer rates (Processor dependent. See Table 1 and Table 2.)
o DDR4 ECC RDIMM up to 2666 MT/s
o DDR4 ECC LRDIMM up to 2666 MT/s
• DDR4 standard voltage of 1.2 V
1.1.3 System Configuration Notes
• Single processor configurations require the processor to be installed in the processor #1 socket.
• Processor #2 must be installed to use any of its 12 associated DIMM slots.
• To ensure systems meet necessary airflow and thermal requirements, the processor #2 heat sink must be installed at all times, with or without
a processor present.
• Support for riser card slots 2 and 3 requires that two processors be installed.
• Riser card slots 1 and 2 can provide a maximum power of 75 W to each installed riser cards. PCIe* add-in cards that require more power than
is available directly from the riser card must route the additional power directly to the add-in card from either of the two onboard 12V auxiliary
power connectors using a 12V-AUX Power Cable available as a standalone accessory (AXXGPGPUCABLE) or included with some riser card
accessory kits.
To Next Page
Need help?
General
