Intelbras AMT 4010 Smart - Zone Attributes (as of Version 1.90)

15
After introducing the programming (select which partition and zone group) dene
which zones will be active in the partition so that the zone marker is selected. Repeat
the same programming for the other partitions and zone groups (zones 1 to 8 will
always be shown in each programming).
Obs.: If no zones are dened for the partition, it will remain inactive.
Password Permissions
Enter + 2 + P + G + Enter + select the group passwords + Enter
P = Permission: 1 = partition A / 2 = partition B / 3 = partition C / 4 = partition D
G = Password Group: 0 = passwords 1 to 8 1 = passwords 9 to 16 2 = passwords 17
to 24 3 = passwords 25 to 32 4 = passwords 33 to 405 = passwords 41 to 48 6 =
passwords 49 to 56 7 = passwords 57 to 60
Attention: in addition to the above programming items, it is necessary that user
passwords be created/set (Password Registration topic) in addition to the registration
of wireless controls for access (Remote Control topic).
3.7. Zone attributes (as of version 1.90)
(Programming only by the installer)
Note: the Zone Attributes function has been removed as of version 5.0.
Enter + 3900 + XX + Enter, where XX goes from 01 to 64
3900 Zone 01 to 64
Key 1 Enables the zone
Key 2 Has permission on partition A
Key 3 Has permission on partition B
Key 4 Has permission on partition C
Key 5 Has permission on partition D
Note : each zone can have permission on only one partition. If you check the permis-
sion on more than one partition, the rst one checked is the one that counts.
Enter + 3901 + XX + Enter, where XX goes from 01 to 64
3901 Zone 01 to 64
Key 1 Smart Zone
Key 2 Fast Zone
Key 3 Quiet zone
Key 4 NA Zone
Key 5 Presence annunciation zone (chime)