8
If you wish to access the alarm center with one of our compatible applications via
CLOUD, just use the QR CODE reader of the application, read the QR CODE code from
the label on the cover of the center and it will automatically ll in the MAC, Master
password and Remote Access password elds in the application.
If you want to use any other feature of the center that requires a Master password (4
digits) or a Remote Access password (6 digits), use the passwords that are registered
in the QR CODE tag.
Note:
»
the Master password (4 digits) and also the Remote Access password (6
digits) can be changed according to the user’s needs using the keyboard command,
as shown below:
1.
To change the Master Password, type
: Enter + Current Master Password +
Enter + 20 + 00 + New Password + Enter
;
2.
To change the Remote Access Password, type:
Enter + Installer Password +
Enter + 20 + 63 + New 6-digit Password + Enter.
After the changes made in commands 1 and 2 above, the changed passwords
will become the new Master and remote access passwords, that is, the pas-
swords registered in the label will no longer be valid.
By performing a general reset, the Master password will go back to being:
1234
and the Remote Access password will go back to being:
878787.
3.2. Passwords programming 1
(For master user’s programming only (see item 3.1. New QR CODE Label))
Register password
Enter + 20 + ?? + (4 or 6 digit password) + Enter
?? = password number
00 = master password
01 to 60 = secondary passwords
61 = duress password
Register temporary password
Enter + 27 + ?? + (4 or 6 digit password) + Enter
?? = password number 01 to 60 for temporary passwords
To Next Page
Loading...
