40
3.35. Reset by programming mode
Enter + 0000 + Enter
This command delets all settings from the center, except wireless devices and LCD
keypad messages.
Note: this command deletes only messages such as Alarm Center Name and Edita-
ble Message (line 1 and line 2).
3.36. Bootloader
This feature is an option to update the center´s software using a USB AB cable (not
supplied by Intelbras) connected to the computer. This update must be performed by
a qualied person, before using it, consult Intelbras technical support to download
the
Bootloader Wizard App
software and also to learn how to use this feature.
Attention: Wireless communication technology, when exposed to environments
with high power radiation, can suffer interference and have its performance impaired,
for example: locations near TV towers, AM/FM radio stations, amateur radio stations,
etc. It is advised to use mixed connections for increased safety.
3.37. Bus device recognition (as of version 5.0)
Every time the center is powered on, it checks which bus devices are present. For each
device found, it generates event 3 531 - Bus device addition along with its index,
similar to the table below.
Device Event Index
XAT 1 to 4 3 531 – Adding a device on the bus 1 a 4
XAR 1 to 4 3 531 – Adding a device on the bus 5 a 8
XEP 1 to 4 3 531 – Adding a device on the bus 9 a 12
XEZ1 to 4 3 531 – Adding a device on the bus 13 a 18
Note:
this event is generated once, and occurs when the center is turned on.
To Next Page
Loading...
