Intelbras AMT 4010 Smart - Current Setting of the Siren and Auxiliary Outputs; Easy Registration of Wireless Devices (as of Version 1.90)

22
Conguration of the communication busbar of the alarm center by key-
board (as of version 1.8.0 of the AMT 4010 Smart/AMT 4010 Smart Net)
Enter + 517 + Enter + Key 1 to 8 + Enter
Key Busbar Busbar Device
1 - T1T2 - AB Keyboard 1
2 - T1T2 - AB Keyboard 2
3 - T1T2 - AB Keyboard 3
4 - T1T2 - AB Keyboard 4
5 - T1T2 - AB Receiver 1
6 - T1T2 - AB Receiver 2
7 - T1T2 - AB Receiver 3
8 - T1T2 - AB Receiver 4
3.14. Current setting of the siren and auxiliary outputs
(Programming only by the installer)
Enter + 5 6 + ? + Enter
Setting
Setting Siren (A) Auxiliar (A)
0 1,0 0,5
1 1,0 1,0
2 1,3 0,7
3 1,5 0,5
To perform the settings below enter programming mode using the installer password.
3.15. Easy registration of wireless devices (as of version 1.90)
Note: as of version 3.30 of AMT 4010 SMART and AMT 4010 SMART NET it will not
be possible to register devices out of programming mode.
We do not guarantee the registration/functionality of our cen-
ters with wireless sensors that are not manufactured by Intelbras.