23
Introduction
This section of the handbook describes how to setup your Satellite TV
System after installing the ACU. It includes the following functions:
• System start up.
• Changing the default satellite.
• Monitoring the antenna status.
• Setting sleep mode.
• Entering setup mode.
• Setting the satellite pair.
• Editing satellite information.
• Setting the antenna parameter.
• Setting the LNB local frequency.
• Setting GPS.
• Setting the DiSEqC method.
• Display versions.
• Display power status.
• Setting antenna go position.
• Setting antenna move step.
• Setting remote control.
• Setting the factory default parameters.
• Performing diagnostic tests.
Note: Many of the above functions will only be required only after
initial installation of your system. Refer to the Quick Installation Guide
before operating the system.
Operation Instruction
To Next Page
Loading...
Need help?
General
