Intercall 600/700 Installation & Operation Guide Issue 4.27 Page 42 of 78
DPU414 Thermal Printer.
The DPU414 Printer is used in conjunction with the L747 to provide a permanent record of all system activity together
with the date and time. The unit is supplied with parallel data lead for connection to the L747, separate mains ac power
supply and integral back up battery. Please unpack the printer carefully and retain the DPU414 operation manual for
future reference. Please see page 38 for more information on the L747 Interface.
Loading paper the Paper:
c Open the roll cover by pushing it back and lifting it up.
d Unwrap the paper roll and cut the paper end straight across.
e Make sure the paper is the correct way round, with the glossy side showing.
f Push the tip of the paper into the inlet at the bottom of the paper holder, until the auto-loader catches it.
g The auto paper feeder will pull through 10cm of paper which will show from the paper outlet.
h When the paper has loaded successfully, Press the ON LINE button so that the Green ‘ON LINE’ LED is lit.
i Close the paper roll cover and pull it towards the front of the printer to lock it.
c
d
g
Í
e
Power Switch
FEED Button
Serial Connector
Paper Cover
To Next Page
Loading...